The SPR F3 builds on tried and tested software, processor and sensor technology to make your aircraft fly like it's on rails.
Use all the features all the time; e.g. Connect your OSD + SmartPort + SBus + GPS + LED Strip + Battery Monitoring + Sonar + 8 motors - all at the same time!
The SP F3 runs Cleanflight which can be configured to suit your needs using a cross-platform GUI (Windows/OSX/Linux).
Tiny and lightweight
The RacingF3 has a standard 36x36mm form-factor with 30.5mm mounting holes and weighs just 6 grams.
Full support for OneShot ESCs for easy PID tuning and a sharper response.
Broad RC receiver Support
Supports SBus, SumH, SumD, Spektrum1024/2048, XBus, PPM, PWM receivers. No external inverters required (built-in).
Dedicated output for programmable LEDs - great for orientation, racing and night flying.
Supports OneShot ESC and more than 8 RC channels.
Supports more flight controllers, including CC3D, CJMCU and Sparky.
Additional PID controllers that uses floating point arithmetic operations. (now has 3 built-in PID Controllers)
Many more features such as RGB LED strip support, Autotune, In-flight PID tuning with your radio, blackbox flight data logging etc.
Better coding practices and introducing tests, easier to maintain and for future development. (Dominic has software development background)
36x36mm board, 30.5 mm mounting holes.
High-capacity Flash (Acro 6DOF)
MPU6050 Accelerometers and Gyroscopes
|MicroUSB socket||4 x 4 pin JST-SH Socket (I2C, SWD, 2xuart)
2 x 8 pin JST-SH Socket (PPM, PWM, SERIAL RX, GPIO, ADC, 3V, 5V, GND)
8 x 3 pin though-holes for pin headers for ESC / Servo connections
2 x 4 pin though-holes for the 2x serial ports
2 x 2 pin though-holes for battery voltage and buzzer
|1 x Upgrade NAZE32 SP Racing F3 Flight Control for Multicopter|
|2 x 8p Wire Rod|
|2 x 4p Extension Path|
|5 x Pins set|