Creality Ender-3 S1 Pro 3D Printer

Q1: How do I load supplies for the first time?

A: Turn on the machine - prepare - feed/unload - nozzle temperature - set the temperature above 185°C. Cut off the front end of the filaments at a 45-degree angle and straighten the filaments in front, put the filaments through the breakout detection hole first, followed by pressing the extruder handle and letting the filaments insert along the extruder hole again until the nozzle position. When the temperature reaches the set target value, you can see the filaments flowing out at the nozzle and the loading is completed.

Q2: Does Z-axis limit switch need to be installed?

A: No installation is required by default. When the auto-leveling CR-Touch fails, the Z-axis limit switch needs to be installed, and manual leveling is needed.

Q3: What is the maximum idle speed the machine can reach?

A: Maximum running speed 250mm/s

Q4: Does the machine support laser engraving?

A: Yes. Laser engraving accessories can be purchased in Geekbuying store.