- Shipping Company Estimated Delivery Time Shipping Cost
Highlights
- Solid, durable and stable frame, centroid and center of gravity are the same even with battery installed
- Prebuilt frame and extra accessories
- Powerful EMAX power system and open source flight controller to ensure power and customizability(RTF model can fly after battery and propellers installed)
- The sturdy copter frame has gone through extensive flight test and endurance test
- Bright COB rear LED, multi LED color to distinguish itself among copters during group flying (LED power consumption is 4W, which might decrease flying times.)
- All in one design, combining ESC, BEC, and flight controller for easy installation and replacement
- Plug and play motor, easy for swapping motor without soldering requirements
- Independent ESC, flight controller and power supply. ESC switch to perform single ESC calibration and boot pad to perform software and firmware upgrade
- Flight controller with built-in 32bit ARM micro processor, accelerated process to ensure acute response
- Gyroscope, magnetometer, accelerometer and barometer expansion port, CPPM receiver GPS feature available (GPS module sold separately)
- Support ANGLE, HORIZON, HEADFREE, MAG, HEADADJ ...etc modes
- Support RC Input: standard signal, CPPM (PPM SUM) signal, PWM signal
- Low voltage monitoring and low voltage warning (Buzzer sold separately)
- EMAX 12A ESC, open source BLHeli and ONESHOT support; flight controller based on NAZE32 Skyline32, open source configurator for Baseflight and Cleanflight support
- Extra power output and power output switch for LED expansion
Emax NightHawk Pro 280 Intro HD
Specification
Specification| General | |
|---|---|
| Brand | EMAX |
| Model | Nighthawk Pro |
| Quantity | 1 Piece |
| Specification | |
| Wheelbase | 280mm |
| Motor | MT2204(Customizable Version) |
| ESC | BLheli 12A 4in1(Integrate on board) |
| Propeller | 6045 |
| Flight Controller | Skyline32(Integrate on board) |
| FPV Camera | 1/3-inch CMOS |
| Antenna | 5.8G Clover 3 Blade Antenna Straight Connector |
| FPV Transmitter | 20MW/200MW |
| Suggested Configuration | Battery: 3S,1500-2200mAH 30C |
| Dimensions & Weight (Main Product) | |
| Dimension | 252mm*260mm*75mm |
| Weight | 440g |
| Package Contents | |
| 1 X EMAX Nighthawk Pro 280mm Quadcopter | |
| 1 X Transmitter | |
The Nighthawk Pro was designed from the ground up to meet the exacting specifications of the Drone Racer. It comes fully tuned with the new Skylight 32 integrated flight control board together with four 12Amp BLHeli One shot speed controllers. The power system consists of EMAX 2204 2300 kV motors and 6045 propellers mounted on a 10 degree tilt allowing fir greater forward speeds without sacrificing elevation. When it comes to the FPV racer, the Nighthawk Pro 280 includes a 700TVL camera with optional tilt mounts that extends a stunningly horizontal view in flight, and a 20W-200W video transmitter with a selectable switch for optional transmitter power output. It is, without a doubt, an exciting new quadcopter that captures the joy of quadcopter racing!
