This receiver is tested with DJT modules and Taranis internal module. It is compatible with FrSky D8 protocol. The basic failsafe is on channel 3 (Throttle). Using this receiver will need soldering skills. Please note receiver is using CC2500 without external PA and LNA. This receiver is great for backyard or park flying. Please only use this receiver for micro's (meant to be used on indoor and/or small vehicles). Do not use this receiver on a bigger Quadcopter.
|8 channels (only PPM signal)|
Antenna Length: 30mm
|Binding||1. Remove all power.
2. Turn your TX on in binding mode. (D8 mode on Taranis)
3. Connect the PPM to GND
4. Once bound you should get a steady slow blinking light
5. Remove all power
6. Make sure PPM and GND are no longer shorted(connected).
7. Reset TX or Turn off binding mode.
8. Turn on your TX and RX.
9. You should now be bound
|1 x Frsky PPM Receiver|