- HC-06,a slave module,interface including VCC,GND,TXD,RXD,STATE,EN
- State interface can tell the status of LED, EN means enable the pin
- Current<20uA when it is closed
- LED indicate the status of bluetooth connection: LED flashing:bluetooth disconnected;LED being lighted:bluetooth connected
- Anti-reverse diode,with 3.3V LDO
|Input Voltage||3.6-6V(can not be higher than 7V)|
|Current||30mA when unparied;10mA when paried|
|Interface level||3.3V,can be connected with various SCM directly, such as: 51, AVR, PIC, ARM, MSP430, etc. It is not allowed to connected with MAX232|
|Effective Distance||10 M|
|Compatibility||Computer,cell phone,PDA,PSP (which with bluetooth function)|
|1 X HC-06 Bluetooth module|
After paried, it can be used as full-duplex serial, it does not need anything about bluetooth protocol, but only support 8 data bits, 1 stop bit and no parity communication format.
When it without bluetooth connection, it support baud rate, name, passkey through AT command. The information will be saved when power is off. After connection, it will be changed to pass-through mode automatically.