Geprc RUN HD 3 155mm 3 Inch FPV Racing Drone With STABLE PRO F7 35A BLHeli_32 ESC DJI FPV Air Unit BNF - Frsky XM+ Receiver

General

Brand: Geprc
Model: RUN HD 3
Weight: 201g(Without Battery)
Version: BNF
Receiver: Frsky XM+

Specification

Frame Kit:

Wheelbase: 155mm
Mounting Holes: 30.5*30.5mm/20*20mm
Side Plate: 1.5mm
Top Plate: 2mm
Bottom Plate: 3mm
Side Plate: 2mm

FPV SYSTEM : DJI FPV Air Unit

Operating Frequency: 5.725-5.850 GHz
Transmitter Power (EIRP): FCC/SRRC: <30 dBm; CE: <14 dBm
Min. Latency (end-to-end)
Low Latency Mode (720p/120fps): <28 ms
High-Quality Mode (720p/60fps): <40 ms
Max. Transmission Distance: FCC/SRRC: <4 km; CE: <0.7 km
Video Format: MP4 (Video format: H.264; Audio format: ACC-LC)
I/O Interface: USB-C, MMCX, 3-in-1 port, microSD card slot
Operating Temperature Range: 32° to 104°F (0° to 40°C)
Input Power: 7.4-17.6 V, about 4-9 W
Sensor: 1/3.2” CMOS; Effective Pixels: 4 M
Lens: 2.1 mm, f/2.1
Shutter: Rolling shutter
ISO: 100-25600
FOV: 150°(D); 122°(H); 93°(V)
Dimension: 22.1 × 21.1 × 20.1 mm

STABLE PRO F7 Flight Controller:

Model:STABLE PRO F7 35A
MCU: STM32F722RET6
IMU: 2x ICM20689(SPI)
BlackBox: 32Mb onboard Flash
OSD: BetaFlight OSD w/ AT7456E chip
Baro: NO
BEC Output: 5V@3A
Integrated LC Filter
Input Voltage: 2-6S Lipo
Firmware Target: EXF722DUAL
Size: 26x26mm board, 20mm mounting holes (M2)

STABLE PRO F7 ESC BL32 2-6S 4in1: 

MCU: STM32F051
Input: 2-6s lipo
Constant: 35Amps
Burst: 45Amps
Dimensions: 31*31mm(including the power pads)
Mounting Holes: 20*20mm,M2
Supports Dshot1200,Proshot,Oneshot,Multishot
Current Meter: Yes
Target: GEPRC-BL32-4IN1

Motors: GR1507 3600KV
Prop: 3inch 3042 3-blade

Recommended Battery: 4S 850mAh (Not inclueded)

Weight & Dimensions

Package Weight: 0.48kg
Package Size (L x W x H): 25 x 25 x 7cm

Package Contents

1 x Geprc RUN HD 3 Racing Drone(BNF Version)