Happymodel Snapper7 75mm FPV Brushless Whoop Racing Drone with Crazybee F3 OSD 5A ESC Frsky Receiver BNF - One Battery

Brand Name: Happymodel
Mode Name: Snapper7
Item Name: 1S Brushless Whoop racer drone BNF
Wheelbase: 75mm
Size: 98.5 x 98.5 x 36mm
Weight: 28g(without battery)

Motor
Mode: SE0703 KV19000
Configu-ration:9N12P
Stator Diamter:7mm
Stator Length:3mm
Shaft Diameter:Φ1.0
Motor Dimension(Dia.*Len):Φ10*14.5
Weight(g):2.5
No.of Cells(Lipo):1S

Flight controller
Firmware: Betaflight_3.3.0_Crazybee
MCU: STM32F303CCT6 (72MHZ, 256K FLASH)
Sensor: MPU-6000(SPI connection)
Board size: 28.5 * 28.5MM
Board weight: 3.5 g
Power supply: 1S battery input (DC 3.5-4.35V)
Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
Built-in Frsky receiver with telemetry(D8/D16 switchable)
Built-in Betaflight OSD(SPI Control)
Built-in Current meter (Max 14A,could be modified to 28A by replace resistor)
Built-in 5V 0.8A BEC with LC filter
Built-in voltage detection
BLHELI_S pass-through Ready
Heading LED Ready

Onboard 4in1 ESC
Power supply: 1S LiPo/LiPo HV (4.2v/4.35v)
Current: 5A continuous peak 6A (3 seconds)
Support BLHeliSuite programmable
Factory firmware: O_L_5_REV16_6.HEX
Default protocol: DSHOT600

Frsky Receiver Version
SPI BUS receiver
Frsky D8/D16 switchable
Compatible both of Non EU and EU LBT transmitter
Channels: 8ch or 16ch
Failsafe support
No ground interference ( Transmitter and receiver 1 m from the ground): 300m

AIO Camera & VTX
Output power: 25mw
Frequency: 48CH
Input voltage: 3.3V 5.5V
Current consumption: 300mA(type)

1 x Happymodel Snapper7 Racing Drone
4 x 40mm 3-Blade Propellers ( 4 CW & 4 CCW)
1 x 3.8v 450mah 30C/60C Lipo battery
1 x USB Lipo/LIHV Charger
1 x Propeller Disassemble Tool
1 x Screwdriver