Holybro Kopis 2 SE FPV Racing Drone Kakute F7 OSD FC Tekko 32 BLHeli_32 4In1 Dshot1200 ESC 5.8G VTX Frsky Receiver BNF

Brand: Holybro
Item Name: Kopis 2
Product Size: 23.4 x 20.4 x 4.6cm
Product Weight: 299g
Arm Plate Thickness: 5mm
Bottom Plate Thickness: 4mm
Motor: T-Motor F40 Pro2 2400KV
Propeller: Dalprop T5046C
Camera: RunCam Micro Swift
Receiver: Frsky XSR
Package Size: 33.5 x 29 x 6.7cm
Package Weight: 0.989kg

Kakute F7 Flight Controller
MCU: STM32F745 32-bit processor 
IMU: ICM20689 (SPI) 
Barometer: BMP280 
Current Sensor: Approximately 130 amps maximum measurable value 
USB VCP Driver (all UARTs usable simultaneously; USB does not take up a UART) 
6 hardware UARTS (UART1,2,3,4,6,7) 
All UARTS support hardware inversion. SBUS, SmartPort, and other inverted protocols work on any UART without "uninvert hack" 
Supports serial receivers (SBUS, iBus, Spektrum, Crossfire) only. PPM and PWM receivers are not supported 
TF card for Blackbox logging 
Mounting Holes: Standard 30.5mm square to center of holes

Tekko 32 BLHeli_32 4 In 1 Dshot1200 ESC
Supports 3-6S lipo input 
35A continuous current, 50A burst 
Mounting holes 30.5x30.5mm 
Size: 55*40*6.4mm 
Weight: 17g
32bit ESC with BLHELI32 firmware
4PWM input
Voltage output (VBAT), ESC Telemetry(TELEM)
Supports Oneshot / Multishot / Dshot PWM
Supports damped light
NO BEC

5.8G 40CH VTX
Output Power: 0.5mW (pit mode), 25mW, 200mW, 500mW, 800mW 
Audio: 6.5 MHz Mono 
Antenna Connector: MMCX 
Input Voltage: 7 to 28 volts (2-6S LiPo) with absolute maximum 42 volts 
Dimensions: 35x25x7mm (Includes USB height) 
Mounting Holes: Standard 30.5mm square to center of holes 
Weight: 9.3g

1 x Holybro Kopis 2 FPV Racing Drone BNF(with Frsky XSR Receiver)