Ship to:
Germany
Select the desired shipping method
- Shipping Company Estimated Delivery Time Shipping Cost
Trusted Shipping Partners: 
and more
Highlights
- Support the GOPRO Hero3 video aux output
- Support the power supply voltage reverse connection protection and voltage compensation
- Support for motor drive side short circuit protection
- Support initial pitch angle
- Support the sensitivity parameters adjustment and the software 3 d posture display
- Support the rocker rate model and location
- Support the receiver: conventional receiver S - BUS receiver, DSM2 DSMJ/DSMX receiver
- Support remote control equipment: PPM/PCM / 2.4 G
- Suitable for GOPRO brushless yuntai TL68A08 brushless gimbal or other similar products, used in entertainment, film and television photography, advertising model aircraft photography and so on many fields
Specification
| General | |
|---|---|
| Type | 2 Axis Gyroscope |
| Operating Voltage | 7.4 V ~ 14.8 V DC (recommended 12 V) |
| Work Current | 200 mA - 500 mA (related to the power supply voltage and motor power) |
| Working Environment Temperature | 15-65 Degrees |
| Processor | Dual high-speed 32-bit ARM core processor |
| Sensors | 3 MEMS gyroscope rotor and rotor MEMS accelerometer |
| Maximum Angular Rate | 2000 Degrees / Sec |
| Maximum Acceleration | 16 g |
| Control Frequency | 2000 HZ |
| Motor Drive Frequency | 20 KHZ (noiseless smooth drive) |
| Accuracy | 0.1 Degree |
| Control Range | - 45 ~ 45 Degrees (roll), - 135 ~ 90 Degrees (pitch) |
| Gesture Decoding Algorithm: | Dedicated to brushless motor driven yuntai decoupling EKF algorithm |
| Compatible | GOPRO Hero3 |
|
Gimbal tuning parameter interface |
A serial port module connected to the computer through the USB,used in gimbal main controller tuning parameters and status monitoring |
| Motor drive tuning parameter interface | A serial port module connected to the computer through the USB,is used to adjust the number of motor driver module,power voltage and current monitoring |
|
Receiver steering gear output interface |
R: common receiver roll inputs T: common receiver pitch input C: common receiver model input (rocker arm Angle mode or speed) S: S - BUS receiver channel or photo input channel P: take pictures steering gear output (infrared photo module can be attached) + 5 v output, - : power supply |
| Other interfaces | Satellite interface: used to connect to the satellite receiver Roll motor and pitch interface: used to connect the motor Sensor interface: used to connect to sensor |
| Notice | Please read the instructions in detail before assembly. Non-professionals are supposed to assemble it under guidance of professionals. |
| Package Contents | |
| 1 x ZYX3 rotor gyroscope quad ZYX07 | |
| 1 x GOPRO two axis gyro sensor | |
| 1 x GOPRO gimbal two axis gyroscope main controller | |
| 4 x 4.5x 4.5 MM insulation spacer | |
| 8 x 2x3 mm round head cross screw | |
Customer Photos
Customer Videos
Customer Reviews
Clear
View all
View all
Photos
Videos
All star
All star
5 star
4 star
3 star
2 star
1 star
Most relevant
